In this how to reset Smok Alien to factory settings tutorial we will discuss the first step on how to reset smok alien device. This is a very popular and efficient electrical appliance. It is powered by two Ni-Cd batteries that are placed in the alien device’s base. One of the batteries is meant for charging while the other one acts as a power source. The two batteries have a certain life span and once they have run out of charge, the circuit board will need to be replaced or recharged.

To know how to reset smok alien to factory settings, it is important to first remove the two batteries from the device. On the top side you will see two buttons; one is the power button and the other is the ground button. Press and hold both buttons for about a half a second. The first reaction from the alien device’s electronic circuit board will be to shut down. You might need to do this procedure a few times until the circuit board understands that the power button is no longer pressed.


SMOK Novo X Kit 800mAh

Press and hold both buttons for about a half second and then release the buttons. The two little clips at the back of the device will lift up to release the battery. This is the same process that needs to be done when one is resetting their microwave. After doing so, place the two batteries back into the alien. At this point, you will need to plug the power cord back into the wall outlet. Make sure the power cord is properly aligned with the wall.

Once you have successfully done all of these procedures, place the two batteries back into the device and turn the power back on. The alien should now be working like new again. To learn how to reset smok alien to factory settings, it is recommended that you do not attempt to do any modifications to your smok until you have the proper tools. This article will provide you with a couple of the required tools for performing a complete reset.

The first step in learning how to reset smok alien to factory settings is to remove the battery cover. If your alien came with a battery cover, you will need to unscrew it. If the alien did not come with a cover, you will need to open it up and look inside to see if there are any screws or anything else inside that can be removed. There is a small metal tab that runs across the top of the unit. You will need to use a screwdriver to pry this tab off to expose the screws that will be underneath the plastic tab.

Once you have the screws out, you will need to look for the plastic tabs that were covering the screws. It is best to have a helper or something similar to hold these tabs in place while you remove them. Once you have these removed, you can separate the alien from the battery. The alien should be placed on a table to ensure proper placement. You should have another assistant or two just in case one of the screws accidentally came loose and the alien fell down.


Smok Nord 22 Vape Pen Kit 2000mAh 3.6ml Standard Edition

Next, you will need to take apart the two screws that are holding the alien in place on the bottom of the unit. Once the screws are removed, you will notice that the alien no longer has a rubber or foam covering. You will need to pull the alien apart to see the screws which will be located under the tab. These screws are also accessible by pulling the tab. Once you have unscrewed all of these screws, you will notice that the alien pops out easily and can be placed back into the smok.

Reassembling your smok alien can be quite simple if you have the right tools. If you do not want to mess with the alien unit, you can always take it to a repair shop so that they can look at it for you and determine how you would like to reset it to factory settings. They will most likely charge you for this because it costs them time to process the alien. If you do not have the money to pay for this, you can look online for different instructions on how to reset smok alien. Following these instructions will help you get your smok back in action in no time at all.